--- Log opened zo mei 19 00:00:59 2013 00:34 -!- apuimedo: has quit [Ping timeout: 264 seconds] 00:43 -!- mbetak: has quit [Quit: Leaving.] 01:01 -!- danken: has quit [Quit: Leaving.] 01:06 -!- lhornyak: has quit [Ping timeout: 245 seconds] 01:24 -!- lhornyak (purple): has joined #vdsm 03:55 -!- timothy (Timothy Asir): has joined #vdsm 03:58 -!- timothy: has quit [Read error: Connection reset by peer] 05:33 -!- vvolansk (Vered Volansky): has joined #vdsm 05:37 -!- vvolansk: has quit [Ping timeout: 276 seconds] 05:47 -!- kashyap_ (Kashyap Chamarthy): has joined #vdsm 06:27 -!- lhornyak: has quit [Quit: Leaving.] 08:17 -!- ybronhei1: has quit [Quit: Leaving.] 08:18 -!- ewarszaw (Eduardo Warszawski): has joined #vdsm 08:33 -!- kashyap_: has quit [Quit: Leaving] 08:43 -!- ykaplan (Yeela Kaplan): has joined #vdsm 08:47 -!- abonas (purple): has joined #vdsm 08:55 -!- danken (purple): has joined #vdsm 08:55 -!- mode/#vdsm: by ChanServ 08:56 -!- ybronhei (purple): has joined #vdsm 09:01 -!- ybronhei: has quit [Ping timeout: 256 seconds] 09:14 -!- ybronhei (purple): has joined #vdsm 09:51 -!- abonas1 (purple): has joined #vdsm 09:52 -!- abonas: has quit [Ping timeout: 256 seconds] 09:56 -!- bazulay (purple): has joined #vdsm 10:22 <@danken> amuller: what's up? 10:36 -!- bazulay: has quit [Quit: Leaving.] 10:39 -!- ykaplan: has quit [Remote host closed the connection] 10:43 -!- ykaplan (Yeela Kaplan): has joined #vdsm 10:45 -!- bazulay (purple): has joined #vdsm 11:04 -!- abonas1: has quit [Read error: No route to host] 11:04 -!- abonas (purple): has joined #vdsm 11:09 -!- abonas: has quit [Ping timeout: 276 seconds] 11:54 -!- lhornyak (purple): has joined #vdsm 12:11 -!- danken: has quit [Read error: Connection reset by peer] 12:11 -!- danken2 (purple): has joined #vdsm 12:18 < amuller> danken2: Hi there 12:18 < amuller> danken2: Just came in 12:28 < danken2> amuller: welcome 12:39 < amuller> danken2: Regarding multiple gateways: I setup a manual solution (route file + rule file for every top level device that is added) but there's some issues with it still, and on top of that when I actually set the display network on a 2nd NIC, spice fails to connect 12:39 < amuller> danken2: I discovered that Thursday. I just came in so I'm going to investigate that, but before I actually solve the bug manually I can't start coding it up 12:40 < amuller> danken2: So if I don't solve it by myself today (And I don't think I will) I want to sit with you sometime tomorrow about it if possible 12:42 -!- bazulay: has quit [Ping timeout: 246 seconds] 12:50 < danken2> amuller: to bad, I have no idea why this happens. if you avoid spice, and simply open `nc -l` on the displayNet address, can you connect from the outside world? 12:51 -!- ewarszaw: has quit [Quit: Konversation terminated!] 12:56 -!- ewarszaw: has joined #vdsm 12:56 -!- ewarszaw is Eduardo Warszawski 13:10 -!- abonas: has joined #vdsm 13:10 -!- abonas is purple 13:16 < amuller> Ping to the displayNet address works from outside of the host's network, but nc -l fails: "Ncat: bind to 10.35.16.168:31337: Cannot assign requested address. QUITTING." 13:30 < danken2> amuller: this is not the failure that I've expected. can you bind to other addresses? 13:49 < amuller> Same failure to both NICs of the host 13:50 < amuller> danken2: And to the host below my feet 13:50 < amuller> danken2: So no, I can't netcat to anything 13:51 < amuller> danken2: Without the -l flag it gives me Connection refused 14:01 < amuller> danken2: I just confirmed to eliminate faulty connectivity issues... I ran wireshark on the two NICs of the host, and when I ping the IP of a NIC I get a response from that NIC 14:01 < amuller> danken2: I'll just what happens during Spice now with Wireshark 14:01 < amuller> danken2: I'll check* 14:08 < amuller> danken2: Spice traffic reaches the correct NIC, and I see a bunch of TCP traffic including SYN and FIN. 14:09 < amuller> danken2: Still Spice returns "Unable to connect to the graphics server" 14:21 < danken2> without "-l" nc does not try to listen.. 14:21 < danken2> the fact that it always fails, means that you are not using the command line correctly, amuller. 14:22 < amuller> danken2: Makes sense :) 14:22 < danken2> amuller: it's worthwhile to build nc-nc stream (good practice anyway) 14:22 < danken2> and then try it from server to client. 15:11 -!- danken2: has quit [Ping timeout: 264 seconds] 15:36 -!- abonas: has quit [Ping timeout: 260 seconds] 15:44 -!- abonas (purple): has joined #vdsm 15:54 -!- acathrow (Aic): has joined #vdsm 16:06 -!- bazulay (purple): has joined #vdsm 16:07 -!- mbetak (purple): has joined #vdsm 16:08 -!- shaohef: has quit [Read error: Connection reset by peer] 16:11 -!- abonas: has quit [Ping timeout: 256 seconds] 16:11 -!- abonas (purple): has joined #vdsm 16:16 -!- lhornyak: has quit [Quit: Leaving.] 16:16 -!- shaohef (shaohef): has joined #vdsm 17:01 -!- abonas: has quit [Ping timeout: 264 seconds] 17:01 -!- abonas (purple): has joined #vdsm 17:36 -!- shaohef: has quit [Ping timeout: 245 seconds] 18:03 -!- abonas1 (purple): has joined #vdsm 18:04 -!- abonas: has quit [Ping timeout: 252 seconds] 18:11 -!- ybronhei: has quit [Ping timeout: 240 seconds] 18:38 -!- abonas (purple): has joined #vdsm 18:40 -!- abonas1: has quit [Ping timeout: 264 seconds] 18:57 -!- apahim: has quit [Ping timeout: 248 seconds] 19:09 -!- apahim (Amador Pahim): has joined #vdsm 19:29 -!- abonas: has quit [Ping timeout: 248 seconds] 19:37 -!- ykaplan: has quit [Remote host closed the connection] 19:37 -!- ewarszaw: has quit [Quit: Konversation terminated!] 19:46 -!- bazulay: has quit [Quit: Leaving.] 21:22 -!- mbetak: has quit [Quit: Leaving.] 21:36 -!- bazulay (purple): has joined #vdsm 21:59 -!- bazulay: has left #vdsm [] --- Log closed ma mei 20 00:00:01 2013